How To Debug The Failure Of The Automatic Filling Machine?

Although it is not a common thing for the automatic filling machine to break down, there will always be a day when the machine breaks down, especially for the old filling machine. If the problem cannot be solved for a while, the production cycle will inevitably be extended, and the filling machine will reduce production efficiency.
The filling of the automatic filling machine is inaccurate and will not discharge the material.
1. The filling is not accurate or the material is not coming out. The first thing to do is to check whether the filling mouth is blocked by foreign objects. This is very simple and just clean it up. If there are problems such as filling mouth damage, replace the CBD filling machine with a new one in time. Pretend.
2. Check whether there is air in the conveying pipe of the filling machine. If there is, just remove the air.
3. Check all sealing rings, replace them in time if they are aging or damaged.
4. Adjust the filling speed. The speed of filling will affect the accuracy of filling.
5. The trough material of the filling machine is insufficient, just add new material.
Common PLC faults such as cylinder reset is invalid, solenoid valve coil cannot be powered off, PLC sends a stop signal to the motor and does not stop, and the filling machine motor must be powered off to stop running. If such problems occur in the perfume filling machine, please contact us. Professional development engineers are needed to deal with such problems, and modifying the program is also the most convenient and fastest way to deal with it.
With the rapid development of science and technology, the technology of filling machines is constantly improving, and the equipment is constantly improving. How to correctly install and debug the automatic filling machine will directly affect the quality of the product, and it is also related to the quality of the products. The image of the company's products is a problem, so the correct debugging method is the basis for the normal operation of the filling machine.
The debugging of the automatic filling machine can be divided into three points. First, the high-precision filling machine unscrews the nut of the automatic filling machine and then adjusts the screw so that the position of the lower fixing rod changes accordingly. Thus, the push-pull length of the syringe is also changed to achieve The purpose of free adjustment of the dispensing volume. The screw is adjusted clockwise to increase, and vice versa to decrease. The pointer in the middle is indicating. After adjustment, tighten the nut immediately to make the fixed small metering filling machine rod and crank firmly fixed. Secondly, loosen the nut, and determine the correct position of the upper fixing rod according to the push-pull length of different syringes. After the lower fixing rod is adjusted, turn the crank to make the syringe turn to the top dead center, and then lift the outer sleeve of the syringe about 2mm to avoid The small-dose filling machine can be turned on after the needle tube is broken, and then the screw cap is tightened. Finally, the automatic filling machine is assembled correctly and the switch is turned on. When the machine is working, the crank drives the syringe to pull up and down to pump liquid and adjust the speed knob. , select the appropriate dispensing speed, start to work normally, adjust the governor knob, clockwise dispensing speed is fast, otherwise the speed is slow.