Method for Placing Height Matching Plates

Method 1 for Height Matching Plate Placement

Rotate the Base Plate Lifting Adjustment Knob to lower the Adjustable Base Plate to its lowest position. Then, place an atomizer with a pre-pressed mouthpiece into the atomizer tray (see Figure 1).

Press the Start (Lower) Button to activate the machine. When observing that the Lower Pressing Plate descends to its lowest position, press the Emergency Stop Button to keep the Lower Pressing Plate stationary. As shown in Figure 2, the distance between the lower surface of the Lower Pressing Plate and the upper surface of the Adjustable Base Plate is h = 130mm.

Next, place the atomizer tray (with the atomizer inside) between the height matching plate and the Lower Pressing Plate, and compare their heights (see Figure 3).

Place the height matching plates (available specifications: 40mm, 20mm, 10mm, 5mm) such that the distance between the top of the atomizer and the bottom surface of the Lower Pressing Plate is less than 5mm.

After completing the height matching, reset the Emergency Stop Button, press the Raise Start Button, and the Lower Pressing Plate will return to its original position.

Method 2 for Height Matching Plate Placement

Rotate the Base Plate Lifting Adjustment Knob to lower the Adjustable Base Plate to its lowest position.

Place an atomizer with a pre-pressed mouthpiece into the atomizer tray (see Figure 4), and measure their combined height (denoted as H).

Calculate the required height of the combined height matching plates using the formula: Required Height of Combined Plates = 130mm - H.

Example: If the combined height (H) of the atomizer and the atomizer tray is 36mm, the required height of the height matching plates is calculated as: h = 130mm - 58mm = 72mm. In this case, the height matching plates can be combined as one 40mm plate + one 30mm plate (40mm + 30mm = 70mm).

The remaining 2mm gap can be adjusted by rotating the Base Plate Lifting Adjustment Knob to raise the Adjustable Base Plate by 2mm.