When using a 2g empty disposable pen semi - automatic oil filling machine, accurately debugging the filling volume is crucial for ensuring product quality and production efficiency. The following is a detailed introduction to the debugging steps for you:
Record the target filling volume: Clearly define the amount of oil you expect to fill in each atomizer. For example, if the target is 2g, this will serve as the benchmark value for subsequent debugging. Be sure to record it accurately, which is as crucial as determining the destination coordinates when sailing.
Adjust the machine running speed: Locate the speed adjustment device of the machine, usually a knob or button. Adjust it slowly to achieve a speed suitable for the flow and filling of heavy oil. The speed should not be too fast, otherwise, the oil may splash and the filling may be uneven; too slow will affect production efficiency. You can imagine the process of pouring water. Only when the flow rate is moderate can the cup be filled smoothly. Similarly, a suitable speed enables the filling machine to work smoothly.
Turn on the machine for test filling: After everything is ready, start the filling machine and take several empty 2g disposable pen atomizers for test filling operations. After completion, carefully observe the amount of oil in each atomizer. If the amount of oil is generally too much, you can appropriately reduce the running speed of the machine, or fine - tune the parameters that control the oil filling time (if the machine has this function); if the amount of oil is generally too little, adjust it in the opposite direction. Just like adjusting the heat when cooking, it needs to be adjusted flexibly according to the actual situation.
Weigh again and confirm: Use an accurate electronic scale to weigh the test - filled atomizers one by one. Compare the obtained weight data with the target of 2g and calculate the error. If the error is within an acceptable range (such as ±0.05g), the debugging is basically successful; if the error is large, you need to go back to the previous step and make fine - adjustments again until the expected filling volume accuracy is achieved. This step is like checking the answers after an exam. Only by accurate confirmation can the result be ensured to be correct.
During the entire debugging process, patience is required, and repeated testing and adjustments are necessary. At the same time, regularly check whether the pipelines of the filling machine are blocked and whether the seals are in good condition. These factors may also affect the accuracy of the filling volume. Through scientific and meticulous debugging, the 2g empty disposable pen semi - automatic oil filling machine can exert its best performance and escort the production of atomizers.
